3100 tx line low

Discussion in 'DCT-4' started by wahyu15, Jul 28, 2009.

  1. wahyu15

    wahyu15 Active Member

    Messages:
    140
    Likes Received:
    31
    Trophy Points:
    38
    Getting MCU ID
    Phone didn't answer with TX line low after UEM reset!
    Causes:
    1. put a 27-33 pico capacitor in connector b/w mbus-gnd.
    2. UEM damaged -> replace uem.

    MCU ID: 0xDDDD
    Failed! Aborting!
    Done!
    Phone Restarted...

    kira2 apanya boss
     
  2. apollos

    apollos Well-Known Member Super Member

    Messages:
    904
    Likes Received:
    1,064
    Trophy Points:
    103
    Re: 3100

    Coba cek kabelnya bro...
     
  3. purwanto

    purwanto New Member Super Member

    Messages:
    1,997
    Likes Received:
    4,255
    Trophy Points:
    0
    Re: 3100

    Ini kan sama dgn 1st boot error pada ufs, cek kabel mungkin koneksi krng bagus, jika tetep so hardware nya, cek syarat kerja 1st boot ok.
     
  4. Suvokep

    Suvokep New Member

    Messages:
    869
    Likes Received:
    397
    Trophy Points:
    0
    Re: 3100

    yupp...kabelnya boz pake yg baguz...n cek pin kabel mungkin bengkok or solder lepas/cek juga posisi conection...:clap::clap::clap:
     
  5. djobcomcell

    djobcomcell Well-Known Member

    Messages:
    261
    Likes Received:
    246
    Trophy Points:
    53
    Re: 3100

    pastikan pin kabel terkoneksi dengan pasangannya....
     
  6. sadermo

    sadermo Super Moderators Super Moderator

    Messages:
    2,086
    Likes Received:
    2,110
    Trophy Points:
    123

    maaf saran dri pengalaman

    klo kabel ok,,cobak rehot/rbol cpu :thumb::thumb::thumb:
     
  7. sippo

    sippo New Member

    Messages:
    52
    Likes Received:
    29
    Trophy Points:
    0
    cpu direhoootttt boss dicoba:rock::rock::rock:
     

Share This Page