[BELI] Adaptor HP Siemen

Discussion in 'Handphone & Accesories' started by linksatoe, Sep 10, 2009.

Thread Status:
Not open for further replies.
  1. linksatoe

    linksatoe Active Member

    Messages:
    161
    Likes Received:
    56
    Trophy Points:
    38
    Bos-bos/juragan yg punya Adaptor HP siemen yg bisa buat 20 Unit HP dan udah teruji silahkan hubungi saya.. thx

    id ym : cs_linksatoe
    HP : 085274433000
     
  2. MEICAN

    MEICAN New Member

    Messages:
    93
    Likes Received:
    6
    Trophy Points:
    0
    Iya ngantri juga di pm ya
     
  3. G2Reload

    G2Reload Well-Known Member Product Supporter

    Messages:
    481
    Likes Received:
    289
    Trophy Points:
    73
    Buat sendiri aja boz .. dari PSU baru ato bekas terus diturunin jadi 3.7 - 4.2 v beres dah ... murah, stabil.:rock:
     
  4. odong

    odong New Member

    Messages:
    17
    Likes Received:
    0
    Trophy Points:
    0
    g mn cara buatnya bos?
    nubi ni mohon d bantu
     
  5. linksatoe

    linksatoe Active Member

    Messages:
    161
    Likes Received:
    56
    Trophy Points:
    38
    nyari yang dah jadi aja bos...yg support 20 HP.
     
  6. linksatoe

    linksatoe Active Member

    Messages:
    161
    Likes Received:
    56
    Trophy Points:
    38
    waduh.. ga ada yg jualan adaptor ya bos..
     
  7. serpong4cell

    serpong4cell Moderator Moderator

    Messages:
    1,836
    Likes Received:
    1,256
    Trophy Points:
    0
    ada tapi tanpa trafo mau?
    Soalnya kalau pake trafo berat, harga adaptor ma ongkir gedean ongkir, aku pke trafo 20A untuk catu 32 hp
     
  8. G2Reload

    G2Reload Well-Known Member Product Supporter

    Messages:
    481
    Likes Received:
    289
    Trophy Points:
    73
    Modif PSU komputer dari 5V jadi 4,2V

    Cari IC TL494 kemudian cari pin no. 1 antara pin no 1 ini dan keluaran 5V dihubungkan dengan resistor.

    Ganti resistor ini dengan VR yang nilainya lebih besar kapasitasnya misal Resistornya 9K5 maka ganti dengan VR yang 10K agar bisa ditrimmer voltase keluarannya atau apabila tidak ada VR 10K dan ketemu yang 5K maka hubungkan seri VR 5K ini dengan resistor 5K sehingga beban maksimal 10K atau lebih.

    Standart C55/M55 adalah 4,2 Volt

    Mau pakai 100 HP juga ga masalah asal Watt PSU untuk 5V nya besar.:thumb:
     
    Last edited by a moderator: Sep 28, 2009
  9. linksatoe

    linksatoe Active Member

    Messages:
    161
    Likes Received:
    56
    Trophy Points:
    38
    thanx banget Info nya bos.. cuma saya blank banget masalah elektronika, kalo posting bos ini saya bawa ke bengkel reparasi mudeng ga ya..
    btw.. id ymnya ada ga bos. ntar bisa nanya2 sambil chattingan..thx
     
  10. G2Reload

    G2Reload Well-Known Member Product Supporter

    Messages:
    481
    Likes Received:
    289
    Trophy Points:
    73
    id ym saya : rizaksp silahkan kalau mau tanya2:eek:
     
  11. singan

    singan New Member

    Messages:
    74
    Likes Received:
    0
    Trophy Points:
    0
    bos, pin no.1 yg mn'a.??
    upload gambarnya lh bos..
    Biar lbh enk buatnya..
    Trus jelasi, cr buat'a satu per satu..
    Soal'a ane msh newbie x ne..
    Thanx bos..
     
  12. G2Reload

    G2Reload Well-Known Member Product Supporter

    Messages:
    481
    Likes Received:
    289
    Trophy Points:
    73
    Cari PDfnya dulu donk gan. biar tau kaki no 1 yg mana:)
     
Thread Status:
Not open for further replies.

Share This Page