2310 angkat ic sim card langsung kontak service

Discussion in 'DCT-4' started by Fandi007, Oct 16, 2009.

  1. Fandi007

    Fandi007 New Member

    Messages:
    19
    Likes Received:
    2
    Trophy Points:
    0
    please...help me....para master tolong bantuanx. hp 2310 ku, pas gue angkat ic sim card nya & ganti yg baru dia langsung contact service. terus gue angkat kembali ic nya dia tetap contact service, di mohon bantuannya para master.:)
     
  2. ufa

    ufa New Member

    Messages:
    26
    Likes Received:
    10
    Trophy Points:
    0
    klo g salah cpu nya ikut kpanasan bos ya.....jd coba di ganti/di panasin aja cpu nya,,,trus coba di flash ulang ...di coba ok don't forget thank's
     
    zikrafatan likes this.
  3. Fandi007

    Fandi007 New Member

    Messages:
    19
    Likes Received:
    2
    Trophy Points:
    0
    ok. thanks ats masukanx ntar aku coba. tx
     
  4. Triple_X

    Triple_X New Member

    Messages:
    1,640
    Likes Received:
    758
    Trophy Points:
    0
    coba ini bos...
    If u r suffering from Contact Service while changing SIM IC
    then dont heat UEM directly if pested try this method-
    1. remove keypad sticker
    2.give some heat in the Blue Circle(Shown in picture)
    i.e. opposite side of UEM.
    Then Check ur Mob if OK then
    Enjoy else reball UEM i think reballing is the last sol.
    NOTE- Precaution While Changing SIM IC- Dear put
    a wet cotton (Dipped in Simple Water) on UEM
    then change SIM ic it will protect UEM from heat.
    (just copast)
     

    Attached Files:

  5. tlogo

    tlogo Well-Known Member

    Messages:
    1,504
    Likes Received:
    426
    Trophy Points:
    93
    ....pak boss Q bhs inggris gk ngerti....
     
  6. Triple_X

    Triple_X New Member

    Messages:
    1,640
    Likes Received:
    758
    Trophy Points:
    0
    panasin aja uemnya....
    tapi dari balik pcb...untuk kasus conser karena ganti ic simcard...detil liat gambar..xixixixi
     
    tlogo likes this.

Share This Page