2330 mati

Discussion in 'DCT-4' started by ankwal_cell, Mar 29, 2010.

  1. ankwal_cell

    ankwal_cell New Member

    Messages:
    13
    Likes Received:
    0
    Trophy Points:
    0
    help....kawn2 2330c mati flash saat erase lancar tp saat writing flash lambat n bikin komputr kaya hang tp bisa selesai, content extrct failed, flash mcu+ppm ja tetep hp ga idup....mohon solusinya
     
  2. adityaharisaputra

    adityaharisaputra Moderator Moderator

    Messages:
    793
    Likes Received:
    720
    Trophy Points:
    103
    Koneksi bru trbel boz jd blm bs upload filè erasenya
     
  3. adityaharisaputra

    adityaharisaputra Moderator Moderator

    Messages:
    793
    Likes Received:
    720
    Trophy Points:
    103
    maaf ne boz, tak cri2in ko g ktmu ya boz dkompi ane filnya?
     
  4. andripjm

    andripjm New Member

    Messages:
    173
    Likes Received:
    236
    Trophy Points:
    0

    ok coba kita bahas
    untuk 2330/2323 memang proses flashing ga secepet dct4 yang lain cenderung 50% lebih lambat,extract failed biasanya dari beda versi dari sebelum hp itu mati...alternatifnya kalau hp masuk dalam keadaan mati kita flash dengan versi tertinggi.kemungkinan setelah flash:
    -hp normal
    -conser
    -simlock corup
    jika conser atau sl corup jika rpl bisa di backup,kita backup dulu...setelah itu kita coba full erase,flash dengan versi yang rendah,write pm,unlock,full ui set.......100% tested via mx key (selama mslh software)

    *************************semoga bisa mebantu***************************************************
     

Share This Page