Huawei G6600 MTK 6235 Blink...

Discussion in 'MCNPRO BOX' started by baginda, May 28, 2010.

  1. baginda

    baginda New Member

    Messages:
    28
    Likes Received:
    5
    Trophy Points:
    0
    Selected COM5
    Initialize in progress...
    Checking data, wait...
    Serial Number: MCNXXXXXXXX - XXXX
    Firmware Version: V1.06
    Checksum value: 6FD7-4FBE
    Box Connected!
    Box operating at high speed port: COM5
    --------------------------------------
    Start Scanning...
    ->.....
    scan Result:
    CPU: MT6235.
    GND:1,RXD:4,TXD:3
    >>[G:1 R:4 T:3] Apply to Box
    ----------------------------------------
    you can set Formatting Addr manually
    Please Hold "ON" to connect with the phone...
    Connected to Phone.
    CPU: 6235 Ver: 0001 sw:8A01
    CPU ID: 00000300
    Initialize Boot...
    Nand Flash Type: [ST] ST512R3A
    Nand Flash Code: 00200036(00200036)
    Nand Flash Size: 0x04200000 Hex Bytes
    INT/EXT RAM Size: 0x00010000+0x00000000
    Formatting Nand Flash...
    Nand bad Block: 1
    Format nand OK
    >>Keep the phone on, if you do other operation

    :D :D :D mantapp langsung bikin nota
     
  2. ludvly

    ludvly New Member

    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    0
    ajib bgt boz. berhasil berhasil. hore.
     
  3. dalingwang

    dalingwang New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    0
    Huawei G6600 MTK 6235 Blink...
    Where can the phonesuite for huawei g6600 be found? Or could you give me one? Here is my email address :465725767@qq.com
    Thank you !!!:)
     

Share This Page