2600c CS(full flas+write pm+unlock+ui setting)

Discussion in 'DCT-4' started by ascell, Jun 19, 2010.

  1. ascell

    ascell New Member

    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    0
    kasus pertama kali masuk keypad g bisa satu jalur...
    setelah di raba2 ternyata ic cpu nya bermasalah,
    soalnya di kaki keypad muncul tegangan 3volt...
    nah setelah ganti cpu malah contact service..
    padahal dah di
    fuul erase+
    full flash(oke semua )+
    write PM(oke juga )+
    unlock( step ini malah failed [​IMG] )
    sekarang hp ter sebut g mau di unlock...

    mohon bantuannya bagi yang dah pernah ngalamin....
     
  2. Medcell

    Medcell Member

    Messages:
    64
    Likes Received:
    17
    Trophy Points:
    18
    Kaya'nya ada yg blm dilakukan tu gan,write rpl dr backup an aja.Klo gk ada pake mxkey pasti mak nyuss...
     
  3. tov4n

    tov4n Well-Known Member

    Messages:
    389
    Likes Received:
    1,001
    Trophy Points:
    103
    CPU yg baru bermasalah kek nya gan,
    :thumb:
     

Share This Page