1600 short

Discussion in 'DCT-4' started by daryono, Jul 15, 2010.

Thread Status:
Not open for further replies.
  1. daryono

    daryono Active Member

    Messages:
    259
    Likes Received:
    85
    Trophy Points:
    38
    bos sy mau nanya 1600 short tp ku cabut uem nya dah ga short di sini masalah nya ku ganti uem baru masih short semua capasitor dah ku cabutin satu2 tp tetep saja short tolong dong bos2 djawir kasih aku masukan nya tanx.s
     
  2. dj.orion

    dj.orion Super Moderators Super Moderator

    Messages:
    3,109
    Likes Received:
    5,147
    Trophy Points:
    123
    Short xg dimaksudkan di sini konslet Vbatt atau konslet tegangan kerja.???
    Klo short tegangan kerja, rasa'y sia2 diganti berapa kali pun UEM akan tetap short, krn jalur xg short adalah jalur tegangan output dr UEM.
    Coba angkat kembali UEM tsb n lakukan pengecekan arus dg menyuntik langsung ke titik2 tegangan kerja di pin2 UEM di board.
    Atau barangkali penggunaan panas xg berlebihan pd saat pemasangan UEM sehingga jebol.??? Tp jarang sekali sich.. UEM termasuk ic xg tahan suhu tinggi :rolleyes:.
     
  3. tlogo

    tlogo Well-Known Member

    Messages:
    1,504
    Likes Received:
    426
    Trophy Points:
    93
    ..ya coba cek jalur tegangan out put UEM kemungkinan masih ada capasitor yang short..
     
  4. sadermo

    sadermo Super Moderators Super Moderator

    Messages:
    2,086
    Likes Received:
    2,110
    Trophy Points:
    123
    moga bermanfaat dan sedikit membantu memudahkan dalam pencarian short nya.. :)

    koreksi ya..masih sama sama belajar!!!!
     

    Attached Files:

  5. daryono

    daryono Active Member

    Messages:
    259
    Likes Received:
    85
    Trophy Points:
    38
    tanx.s bos ternyata jalur viana yg short walau pun hmpr 2 mggu aku nyari nya tanxs atas masukan nya bravo forum djawir
     
  6. sadermo

    sadermo Super Moderators Super Moderator

    Messages:
    2,086
    Likes Received:
    2,110
    Trophy Points:
    123
    problem solved

    tread closed

    :closed::closed::closed:
     
Thread Status:
Not open for further replies.

Share This Page