Cpf baru help

Discussion in 'CPF Box' started by daman, Aug 21, 2010.

  1. daman

    daman Well-Known Member

    Messages:
    418
    Likes Received:
    117
    Trophy Points:
    53
    gan tolong sy baru beli cpf box
    udh diinstal konek ok
    sy tes ke hp nexian G901 ( hp normal ) udh di tes pake flashtool pake kabel usb bikin sendiri konek ok
    tapi saya tes detect pinout yg kebaca cuma gnd ( ground ) nya aja,,
    pas saya klik tombol detect trus kebaca gnd, trus sy pencet tombol on/off
    kira2 betul ga begitu caranya,,,,???
    OH IYA sy tesnya pake kabel E107 btul gak tuh???
    MOHON PENCERAHANNYA GAN,,,, UDH PUSING NEH PALA :frusty: :frusty: :frusty:
     
  2. marjoni

    marjoni Active Member

    Messages:
    107
    Likes Received:
    20
    Trophy Points:
    28
    pada saat tekan tombl on/off.muncul tulisan tx berati ok bos.....truskan langkah selanjutnya.
    koreksi bla salah....
     
  3. sloww56

    sloww56 New Member

    Messages:
    285
    Likes Received:
    582
    Trophy Points:
    0

    UNTUK MASALAH KABEL CARI YANG COCOK
    PADA SAAT DETEC RX TX TEKAN TOMBOL ON/OFF TUNGGU SAMPE MUNCUL GND,RX,TX
    KLO GA MUNCUL GANTI KABELNYA..
    KLO MASIH GA KONEK SOLDER PIN BOARD-NYA PAKE KABEL TANPA KEPALA..

    :thumb::thumb::thumb:
     
  4. tomlatu

    tomlatu Well-Known Member

    Messages:
    305
    Likes Received:
    141
    Trophy Points:
    53
    betul pake kabel e107.
    kalo kedetek mestinya:
    MT6225 RX = 7 TX = 9
     

Share This Page