2330c gak coneck

Discussion in 'DCT-4' started by stroy, Sep 17, 2010.

  1. stroy

    stroy Active Member

    Messages:
    102
    Likes Received:
    46
    Trophy Points:
    38
    mohon pencerahan bos,aku punya 2330c mesin masih mulus blm pernah di hardware,keadaan matot
    g bisa di conekan dgn box,jaf/ufs/mx.......tlg dibantu langkah2 hardwarenya bos...:frusty::frusty:
     
  2. astrologsitus

    astrologsitus Well-Known Member

    Messages:
    482
    Likes Received:
    745
    Trophy Points:
    103
    disupply tekan on/off ampere naik ndak gan :rolleyes:
     
  3. stroy

    stroy Active Member

    Messages:
    102
    Likes Received:
    46
    Trophy Points:
    38
    disuply naik bos,tp dari Vflash dan Vana g kluar voltasenya,ada solusi jumpernya g bos...:frusty::frusty::frusty::frusty::frusty::frusty:
     
  4. Nur Alif

    Nur Alif New Member

    Messages:
    153
    Likes Received:
    123
    Trophy Points:
    0
    coba cek kabel ma pinnya juragan...lebih enak lagi kalau ada log diikut sertakan.
     
  5. teresino

    teresino Member

    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    11
    mas bro...

    ane pny mslah yg ky gni sebabny apaan y...maaf masi newby

    MXKEY [MxKey Team HTI PLUS Flasher Interface 6], SN: C08712B6
    Using device: HTI, FW ver: 00.50, SN: 01005C8D
    Connection status: OHCI:HUB:USB 2.00 (Full-speed)
    Driver: WinUSB, ver: 3.5.0.0
    Module ver: 1.0.0.19663(13-12-2011), Library ver: 1.0.0.13672(13-12-2011)
    ERROR: Packet Error(0xAA), code 0xC0000002
    ERROR: Packet Error(0xAA), code 0xC0000001
    Error details:
    Bad contact, TX line remains high !
    VCC_PH BSI TX RX RX2 CLK
    1 0 1 1 1 0
    ERROR: bootstrap failed!

    tolong lah.
     

Share This Page