JUAL RIFF JTAG, Orig, Rp 1.***.000,- FREE kirim ke seluruh Nusantara, www.flasher-box.com | www.yogyaphone.com | www.yogyaponsel.com | www.jogjaflasher.com sms 08122962665 | call 0274-7882374 | call 081802665121 YM hafid_yk, ponsel_yogya, yogya_ponsel, Gtalk yogyaponsel | FB: flasher-box Email: firstname.lastname@example.org 32D4CE0F Senin - Sabtu jam 10-16.30wib, AHad/minggu tutup RIFF JTAG firmware supports following features at the moment: ARM7/ARM9/ARM11 PXA3xx, PXA270, Cortex-A8, OMAP850, Cortex-A9 Dual cores support; Multiple devices on JTAG chain are supported, thus TAP number selection is available; Any custom voltage level selection from range ~1.4V to 3.3V TCK/Adaptive clocking selection Halt core (NRST is not changed) Reset core (NRST is applied before halt) Direct Read memory (by 8/16/32-bit bytes/half-words/words) Direct Write memory (by 8/16/32-bit bytes/half-words/words) Access to the control registers of ARM core (coprocessor 15) Program code breakpoints Run core Custom scripting and DCC loader support (trace32 compatible) Custom GDB Server Available I/O pins detection !Unique feature offered only by RIFF JTAG [video=youtube;luRdICkdkx8]http://www.youtube.com/watch?v=luRdICkdkx8&hl[/video] INFO UPDATE RIFF JTAG, 19.03.2012 RIFF JTAG – HTC EVO View 4G Unbrick, Unlock, IMEI and CID update supported Repairing bricked HTC EvoView4G is easy using RIFF Box. Phone is auto powered on with USB Data Cable connected to the PC while battery is connected. Please note, battery presense is required. Some (or all) revisions of HTC EvoView4G boards have JTAG interface disabled (that is enable MARM JTAG Fuse is blown in the MSM8255 chip). In this case the JTAG may be enabled only by firmware itself. This is done by the FSBL loader, so writing to FSBL area is artificially disabled in the DCC Loader code. DCC Loader will discard all flashing attempts into FSBL zone and will respond with success code as if flashing succeeded. In this way FSBL zone is protected while user still can flash full image files seamlessly. Resurrector will reflash radio’s boot zone (except FSBL area) and will re-write PDA’s SPL to 1.38.0000 version. Additionally to SPL and Radio zones, the zone which contains Model ID is re-flashed too. Thus after resurrection phone will have Model ID = ‘PG4120000’. There is option to reflash BOOT and RECOVERY zones. Please note, if your phone has the FSBL loader damaged and MCU has JTAG FUSE blown then there is no way to resurrect your phone via JTAG interface. To resurrect HTC EvoView4G: Solder JTAG cable to HTC EvoView4G JTAG pads; Insert battery and connect USB Data cable; Make sure HTC EvoView4G is selected in the list of models; If you use only battery, press Power On key; Click Resurrect button; Wait till software signals a successful operation completion; Disconnect power supply, de-solder JTAG wires; Now phone is in bootable condition, that is, even if it does not start up normally you can flash it using known flashing methods. To enter download mode: Disconnect PC cable; Insert battery; Hold ‘Volume Down’ key and press ‘Power ON’ button.