6303i camera

Discussion in 'BB5' started by jorin07, Mar 29, 2012.

  1. jorin07

    jorin07 New Member

    Messages:
    31
    Likes Received:
    1
    Trophy Points:
    0
    help gannnn....6303 camera siap trus klo di bukak,tp hp nya gx nge heng wktu di bukak camera nya,tlg solusinya gannnn....
     
  2. ariemahendra

    ariemahendra Well-Known Member Super Member

    Messages:
    872
    Likes Received:
    577
    Trophy Points:
    103
    cek kaki konektor kamera untuk meyakinkan tidak ada jalur yg putus,ganti modul kameranya,terakhir cek tegangan kerja dari sang kamera.
     
    nerocell likes this.
  3. jorin07

    jorin07 New Member

    Messages:
    31
    Likes Received:
    1
    Trophy Points:
    0
    kyak nya ada se gan yg kaki no 1 gx da arus nya,mw aq juper ke c1482 di situ jg jalur nya ga da,solnya aq lht di schema larinya
    kstu gan,gmn ne solusinya gannnnn?
     
  4. ariemahendra

    ariemahendra Well-Known Member Super Member

    Messages:
    872
    Likes Received:
    577
    Trophy Points:
    103
    pastikan di c1482 kaki positif kluar nilai.klo emang cm itu yah mau g mau di jumper
     
  5. jorin07

    jorin07 New Member

    Messages:
    31
    Likes Received:
    1
    Trophy Points:
    0
    yg aq bingung tu jumper nya hrs kmn lg gann coba agan lht schemanya,ci482 larinya kmn????
     
  6. ariemahendra

    ariemahendra Well-Known Member Super Member

    Messages:
    872
    Likes Received:
    577
    Trophy Points:
    103
    klo kita lihat dari skema,vcap langsung berinteraksi dengan sang modul kamera,wajar klo kaki tersebut saat kita ukur tidak akan mengeluarkan nilai.coba di ukur kaki nomor 2 dan kaki nomor 10 yg sebagai tegangan kerja sang kamera.jika tegangan kerja bagus maka dilanjutkan cek jalur data dari sang kamera ke CPU atau RAPS2.perhatikan apakah CPU tersebut di lem atau tidak.

    mohon dikoreksi dan ditambahkan oleh momod yg lainnya
     
  7. ariemahendra

    ariemahendra Well-Known Member Super Member

    Messages:
    872
    Likes Received:
    577
    Trophy Points:
    103
    sedikit tambahan Vcap itu juga harus mengeluarkan tegangan setara dengan tegangan kerja atau setara dengan Vcc
     
  8. jorin07

    jorin07 New Member

    Messages:
    31
    Likes Received:
    1
    Trophy Points:
    0
    la trus tu kira2 mslh nya di bagian SW pa HW nya gan,,,..
    mhon bantuan nya.
     
  9. ariemahendra

    ariemahendra Well-Known Member Super Member

    Messages:
    872
    Likes Received:
    577
    Trophy Points:
    103
    kebanyakan kasus kamera pd nokia rusak pd bagian hardware
     

Share This Page