minta bantuannnya boss 1202 matot diflash ga mau???

Discussion in 'Nokia ODM' started by devlo, Feb 2, 2013.

Thread Status:
Not open for further replies.
  1. devlo

    devlo Member

    Messages:
    26
    Likes Received:
    13
    Trophy Points:
    13
    1st Boot Err: Bad Resp DCT3, C3 D3 5
    Cannot Detect Mobile Brand
    1st Boot: Ok, DCT4, UPP: 2293 [Rh-112] [2.2.0.0]
    2nd Boot: u3_2nd.fia, Ver: 4.79.0
    Fl0: 0x01000000-0x013FFFFF,00208828,St M58MR032
    Algorithm: u3_st_i.fia, Ver: 4.79.0
    Algorithm Ok, MSID: 84079110782FE8AF331D0E1AB3
    Decoded MSID: 3E4EBAE9-0049FE19-AA000000
    Encoded FAID: DEC76140-A29B33B0-C03E0C4A
    IMAGE: rh122_004.300
    Area1: 0x01000000-0x0100FFFF Erased, Time: 00:01
    Area2: 0x01010000-0x0179FFFF Out of Chip Bounds
    Area3: 0x017A0000-0x017EFFFF Out of Chip Bounds
    Area4: 0x01F00000-0x01FDFFFF Out of Chip Bounds
    MCU Flashing Completed, Time: 00:14
    IMAGE: rh122_004.30md
    Area1: 0x01250000-0x0125FFFF Erased, Time: 00:01
    Area2: 0x01260000-0x0174FFFF Out of Chip Bounds
    PPM Flashing Completed, Time: 00:18
    Flashing Completed, Rebooting Mobile
    Init Local Mode Failed
    IMEI: ---, ASIC:
    UI Defaults Failed
    (pake UFS)

    MXKEY [MxKey Team HTI PLUS Flasher Interface 1], SN: ********
    Using device: HTI, FW ver: 00.50, SN: 0100A1FE
    Connection status: UHCI:HUB:USB 2.00 (Full-speed)
    Driver: WinUSB, ver: 3.5.1.0
    Module ver: 1.0.0.21151(13-07-2012), Library ver: 1.0.0.14214(25-10-2012)
    ASIC ID: 0x2293 [UPPCosto ver: 2.0]
    SecondaryBoot: u3_2nd.fia [DCT4] version: 4.76.0 revision: 0.7 size: 0x9A8
    Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
    FlashID0: 0020 8828 [ST 58WR032FU,32 Mbits] page size: 64 K type: NOR area: 01000000-013FFFFF
    FlashID1: 0000 0001 [unused/removed]
    ExtBUSC: A504 1008 2110 0200 4205 6401 2002 2400
    Algorithm: u3_st_i.fia [DCT4 ALGORITHM] version: 4.76.0 revision: 0.7 size: 0x4C30
    Supported Ids: 3040, 2292, 2293, 3162, 3166, 3168
    Performing Flash Authentication ...OK
    UEM ID: 0049FE19:DA3BDA66
    ASIC type: 11
    UEM Imei: 35319503819800
    Flash Imei: 92B61484784353
    MasterCode: 8EBFA5E54B
    Invalid imei checksum !
    (pake mx key kayak gini)

    kasus 1202 seperti di atas bisa diselesaikan dengan cara gimana master?
    coba dinyalain pake power supply hp cuma ada power sdikit ga mau nyala...
    mohon pencerahannya guru!!! ::still newbie::
     
  2. usnida

    usnida Well-Known Member

    Messages:
    707
    Likes Received:
    204
    Trophy Points:
    53
    1st Boot Err: Bad Resp DCT3, C3 D3 5
    Cannot Detect Mobile Brand
    1st Boot: Ok, DCT4, UPP: 2293 [Rh-112] [2.2.0.0]
    2nd Boot: u3_2nd.fia, Ver: 4.79.0


    ini agak aneh gan....yang atas kedetect dct3 tapi yg bawah ok...
    Invalid imei checksum !

    terus imei invalid...bisa saja hardware nya gan...tapi coba maximalkan aja soft dulu...
    kalau dct4 type2 gini, kalau kasus imei, pengalaman ane, selalu makek cyclone bos....sering tembus kok....di coba pakek cyclone gan...siapa tahu jadi nota...
    kalau boleh tahu, awal nya hp kenapa gan???water damaged ya?
     
    devlo likes this.
  3. devlo

    devlo Member

    Messages:
    26
    Likes Received:
    13
    Trophy Points:
    13
    awalnya masalah led lcdnya ga nyala guru..
    trus tak coba gonta ganti lcd (maklum ada bbrp lcd bekas 1202)
    beberapa kali test pake power supply (udah frustasi tu krn lcd bekas ternyata blank semua)
    abis itu coba pasang lcd baru, pas mau tekan power ternyata udah ga mau nyala lg tu hp, power cuma ada dikit
    stelah itu ane coba software (beberapa kali) hasilnya sperti it...
    maklum bos box cyclone ane blum punya
    ceritanya sperti itu kira2 guru... ::still newbie::
     
  4. devlo

    devlo Member

    Messages:
    26
    Likes Received:
    13
    Trophy Points:
    13
    ternyata saya masih terlalu dini untuk mengatasi masalah ini,
    setelah ane nyerah ane bawa tu hp ke konter yg punya track record bagus (konter X)...
    1202 power hp langsung berhubungan ama lcd< gara2 lepas pasang lcd jalur jd putus semua...
    solusi dr konter X tadi jalur lcd dicek dgn multitester di setiap pin lcd nya kmudian dihubungkan ke ground 1 per 1>
    dr situ ketahuan mana jalur yg putus n gak.
    stelah hp ada power baru lakukan proses flashing kembali... hasilnya... bayar Rp. 20.000 ke konter itu...
    wakakakakak 20ribu dapet 1 ilmu.... 200 ribu dapet 20 ilmu... :D :D :D :STILL NEWBIE::
     
Thread Status:
Not open for further replies.

Share This Page